Dialogic 2000 Series Bedienungsanleitung PDF herunterladen (Seite 5)

• In the VoIP -> General page:

o Set the Transport Type to match IBM Lotus Sametime Unified Telephony

requirements (the default is UDP).

o Set the Telephony Port Interface Side (either all ports or individually). If

configuring the interface side for all ports on the gateway, select ‘all ports‘

from the Select Port to Modify drop down. Then, configure the interface

side to be either Terminal or Network.

NOTE: This has to be opposite of the PSTN trunk configuration. So if the PSTN

trunk is network, then the gateway interface must be terminal.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Dialogic 2000 Series Bedienungsanleitung Seite 5