Dialogic DSI SS7MD Bedienungsanleitung Seite 135
- Seite / 191
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
135
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
— All other bits are reserved for future use and must be set to 0.
7.3.5 MTP_USER_PART – Configure a Local User Part
Synopsis
Configuration of a local user part module, other than a user part which has its own configuration command in
the config.txt protocol configuration file.
Syntax
MTP_USER_PART <si> <module_id>
Example
MTP_USER_PART 0x0a 0x2d
Parameters
The MTP_USER_PART command includes the following parameters:
• <si>
The service indicator.
• <module_id>
The module id of the user process.
Note: This command must not be used when the corresponding configuration commands are used
(MTP_CONFIG, TUP_CONFIG, etc.) since these commands automatically perform the function of
the MTP_USER_PART command.
- Dialogic 1
- DSI SS7MD Network 1
- Interface Boards 1
- Publication Date: July 2009 2
- Document Number: 05-2640-003 2
- Contents 3
- Revision History 6
- Chapter 1: Introduction 7
- 1 Introduction 8
- • Product Identifiers 9
- • Software Licenses 9
- • DSI SS7MDL440Q 10
- protocols are host-based 11
- Interface Board 11
- 2 Specification 12
- • Dialogic 14
- • Country-Specific Approvals 14
- • MTBF Predication 14
- • Warranty 14
- • Software Packages 17
- 3 Installation 18
- • RPM Installation 19
- DM3 Media Board 38
- Linux 1 ms 39
- Solaris 2 ms 39
- • Program Execution Overview 43
- 5 Program Execution 44
- Chapter 6: Message Reference 47
- • mgmt_id 50
- • num_boards 50
- • code_file 50
- • run_mode 51
- • board_id 52
- • ssd_mode 52
- • serial_number 52
- • config_type 53
- • flags 53
- • l1_flags 54
- • l1_resource_id 56
- • enable 57
- • poll_interval 57
- • ntp_management_id 57
- 6 Message Reference 58
- • liu_type 59
- • line_code 60
- • frame_format 60
- • crc_mode 60
- • build_out 60
- • ais_gen 61
- • high_Z 61
- • clk_options 61
- • loop_mode 63
- • prbs_gen 63
- • local_stream 66
- • local_slot 66
- • source_stream 67
- • source_slot 67
- • dest_stream 67
- • dest_slot 67
- • timeslot_mask 68
- • source_st, source_ts 69
- • sc_channel 69
- • ts_mask 69
- • timeslot 70
- • seconds_fraction 76
- • Signaling Unit Data 76
- • maj_rev 77
- • min_rev 77
- • options 79
- • num_streams 79
- • vpi mask 79
- • vci masks 79
- • Cell Stream ID 80
- • upper_stream_id 82
- • link_id 84
- • upper_link_id 84
- • stream 84
- • upper_mod_id 84
- • num_links 90
- • op_evt_mask 95
- • ip_evt_mask 96
- • mgmt_evt_mask 96
- • lsc_state 97
- • cong_status 97
- • num_msgs 97
- • num_rtx_msgs 97
- Value Mnemonic Description 99
- MESSAGE HEADER 100
- Field Name Meaning 100
- Size Name 103
- • failure_code 104
- • event_type 104
- • board_type 104
- • completion_status 105
- • liu_id 106
- • liu_status 106
- • EVENT CODE 107
- • Adjustment timer integer 108
- • Adjustment timer fraction 108
- • state 109
- • version 110
- • duration 110
- • bit_errors 110
- • board_rev 112
- • current_temp 112
- • max_temp 112
- • about_cnt 113
- • CRC_errs 113
- • length_errs 113
- • rx_overrun 113
- • receiver_busy_cnt 114
- • rx_frame_cnt 114
- • rx_pre_filter_cnt 114
- • tx_frame_cnt 114
- • rx_busy_status 114
- 6.9 Message Summary Table 115
- Table 7. Message Summary 115
- • <board_id> 119
- • <board_type> 119
- • <flags> 119
- • <code file> 119
- • <run_mode> 119
- • <build_out> 121
- • <liu_id> 122
- • <sc_channel> 122
- • <ts_mask> 122
- • <mode> 122
- • <timeslot> 123
- • <bpos> 124
- • <stream_a> 124
- • <stream_b> 124
- • <pattern> 125
- • <link_id> 127
- • <user_module> 127
- • <filter> 127
- • <phys_mask> 127
- MTP_CONFIG 0 0 0x00040000 129
- 16-bit Japan 129
- 24-bit ANSI 129
- • <linkset_id> 132
- • <link_ref> 132
- • <slc> 132
- • <dpc> 134
- • <norm_ls> 134
- • <second_ls> 134
- • <user_part_mask> 134
- • <si> 135
- • <module_id> 135
- • <options> 137
- • <num_streams> 137
- • <def_vci> 139
- • <reserved> 140
- • <timer_id> 140
- • <value> 140
- SCCP_CONFIG 123 8 0 146
- SCCP_CONC_SSR 1 2 3 148
- SCCP_TRACE 0x1 0x1 0x1 148
- SCCP_GTT 5 R-/K 9 150
- • <primary_address_id> 151
- • <backup_address_id> 151
- DTC_CONFIG 2 0 0 0xef 152
- • <protocol> 153
- [<addr_format>] 154
- <reserved> 155
- • <op_evt_mask> 156
- • <ip_evt_mask> 156
- • <non_prim_mask> 156
- MAP_CONFIG <options> 157
- MAP_CONFIG 2 157
- MAP_TRACE 0xf 0xf 0x4 157
- INAP_CONFIG <options> 158
- INAP_CONFIG 2 158
- • <ac_ref> 159
- • <ac> 159
- • IS41_TRACE - IS41 Trace 160
- Chapter 8: Host Utilities 161
- • -m<module_id> 162
- • -o<options> 162
- • -f<filename> 163
- • -t[t 163
- 8 Host Utilities 164
- -d -v -t1 -t2 -x] 167
- FORK_PROCESS ./tim_lnx 170
- FORK_PROCESS ./tick_lnx 171
- • -k<config file> 172
- • -m<module id> 172
- • -i<notify module id> 172
- • -v [v ¦?] 175
- • -f <filename> 175
- Sample Output 176
- Glossary 185
Verwandte Produkte und Handbücher für Hardware Dialogic DSI SS7MD
Hardware Dialogic 4000 Bedienungsanleitung
(32 Seiten)
(32 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.065 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern