Dialogic Brooktrout TR1034 BRI Bedienungsanleitung PDF herunterladen (Seite 11)

RightFax 8.5 Fax Board Guide 11

Setting the hardware interrupt

The Brooktrout TR114 series of analog fax boards also requires you to configure an interrupt setting

on each board. The interrupt value is selected on the board using a jumper (which looks like a small

plastic cap covering two wires). Refer to your Brooktrout documentation for the location of the

interrupt header on your fax board model.

All Brooktrout TR114 fax boards installed in the same computer must use the same interrupt setting.

If a TR114 is already installed and operating, and you add another TR114 board, you must set the

hardware interrupt on the new board to the same value as the currently installed board.

The default interrupt setting for all Brooktrout TR114 series fax boards is 5. You can use this setting

or use any other interrupt setting that does not conflict with other devices on the computer. On

some computers, interrupt 3 may cause a conflict with the second serial port, and interrupt 4 may

conflict with the first serial port. If all of the Brooktrout TR114 boards are installed in 16-bit slots,

interrupts 10, 11, and 15 are often your best choices.

Note If you have a combination of ISA and PCI TR114 fax boards, you must set the interrupts used by your

ISA cards as “ISA only” in your server BIOS.

Installing Brooktrout TR114 fax boards

Fax boards can be installed in the RightFax server or in a separate computer called a “remote

BoardServer.” For information on using remote BoardServers, refer to the RightFax Administrator’s

Guide.

Warning Never insert a loop-start line into a DID port. Doing so will damage the fax board and void all

warranties. If you have any doubts, test the phone line with a volt meter prior to connecting it to a DID port to

ensure that no current exists on the line.

After all of your Brooktrout TR114 fax boards are configured to use the proper

I/O addresses and hardware interrupt, you are ready to install them. Always turn your computer

off before inserting or removing any board, and take all necessary precautions to prevent static

discharge when handling any fax board. ISA TR114 boards can be installed into either an 8-bit or 16-

bit slot in an ISA or EISA computer. PCI boards can be installed in any PCI bus slot.

After the fax boards are properly installed, refer to your Brooktrout documentation for instructions

on connecting the DID and/or loop-start phone cables and optional power supply.

Completing the installation of your Brooktrout TR114 fax boards

After your Brooktrout TR114 fax boards have been installed, you should test the fax channels to

ensure that the boards have been properly configured and installed. For information on testing your

fax channels, see “Testing Brooktrout Loop-Start Boards” (page 14), and “Testing Brooktrout DID

Boards” (page 15).

When you have completed installing and testing your Brooktrout TR114 fax boards, you must

configure the RightFax software to communicate with the boards. For information on configuring

RightFax to work with your fax boards, refer to the chapter on configuring the RightFax

BoardServer in the RightFax Administrator’s Guide.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Keine Kommentare

Dialogic Brooktrout TR1034 BRI Bedienungsanleitung Seite 11