Dialogic 4000 SERIES Bedienungsanleitung PDF herunterladen (Seite 53)

Dialogic® Diva® SIPcontrol™ Configuration

Page 53

Address Maps

In general, address maps should be used for cases that are not covered by the dialplan. Possible scenarios are:

• Set the calling number to that of the central office on SIP to PSTN calls,

• Change the called extension to another value if an employee left.

• Remove trunk prefixes while routing to a global voicemail server.

Each address map consists of a number of rules that are checked and applied from first to last until a matching

rule is found that has the Stop on match option enabled. A rule matches only if all conditions of that rule match.

The order of the address maps is not important, but the order of the rules within a map is significant and can

be changed with the "arrow down" and "arrow up" buttons in Microsoft

Internet Explorer

or the Up and Down

buttons in Mozilla Firefox.

To add an address mapping, click the Add button. To change the settings for each address mapping, click the

Details button on the right hand side. To open the online help for a specific parameter, click the parameter, and

a window with the help will appear.

You can configure the following parameters when you create or modify an address map:

Access code: Enter the digits that are needed to get access to the public network, e.g., 9.

PSTN access code

provided by SIP

caller:

Select this option if the SIP caller has to provide the access code. If the length of the called

number is not sufficient to identify it as an internal number, activate this option to avoid

ambiguous numbers. This is usually the case if you are not using the North American

Numbering Plan (NANP).

Incoming PSTN

access code provided

by PBX:

Select this option if the PBX adds the access code to the calling number for incoming external

calls.

Address map name: Enter a name for the address map that helps you remember the purpose of the map. This

name is shown in other menus where an address map can be selected.

Note: The name can be edited only during the creation of an address map.

Rule name: Enter a name for the rule of the map, e.g., "Remove 9 from all incoming calls".

Stop on match: This flag determines whether Diva SIPcontrol should continue to search for matching rules

when all expressions match all addresses of a call. If set, the address matching is aborted

when there is a match.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 167 168

Keine Kommentare

Dialogic 4000 SERIES Bedienungsanleitung Seite 53