Dialogic 4000 SERIES Bedienungsanleitung PDF herunterladen (Seite 81)

Cause Code Mapping

Page 81

CHAPTER 11

Cause Code Mapping

If Diva SIPcontrol uses Microsoft

Office Communications Server 2007 or Lync Server 2010 as a SIP peer, the

cause/response code tables are used as specified by Microsoft. See Default Cause Code Mapping for Microsoft®

Office Communications Server 2007 and Lync Server 2010 Peers on page 83 for a detailed list of cause/response

codes.

If Diva SIPcontrol does not use Microsoft

Office Communications Server 2007 or Lync Server 2010, the default

cause/response code mapping is used. See Default Cause Code Mapping below for a detailed list of

cause/response codes.

Default Cause Code Mapping

Diva SIPcontrol includes a default cause/response code mapping table that includes the most common cause

codes according to RFC 3398 and RFC 4497. If you need to define a cause code mapping other than in the table,

you can configure it in the Cause Code Maps section.

For ISDN to SIP code mappings, see ISDN

Cause Code to SIP Response Code, below.

For SIP to ISDN code mappings, see SIP Response Code to ISDN Cause Code on page 82.

ISDN Cause Code to SIP Response Code

ISDN cause

code

Description SIP response code

forwarded to the

SIP peer

Description

1 Unallocated number 404 Not found

2 No route to specified transit network 404 Not found

3 No route to destination 404 Not found

16 Normal call clearing 603 Decline (The PBX of Philips sends this code

during call set-up if the user rejects the

call.)

17 User busy 486 Busy here

18 No user response 603 Decline (The PBX of Philips sends this code

during call set-up if the user rejects the

call.)

19 No answer from the user 480 Temporarily unavailable

20 Subscriber absent 480 Temporarily unavailable

21 Call rejected 603 Decline

22 Number changed 410 Gone

23 Redirection to new destination 410 Gone

26 Non-selected user clearing 404 Not found

27 Destination out of order 502 Bad gateway

28 Address incomplete 484 Address incomplete

29 Facility rejected 501 Not implemented

31 Normal, unspecified 480 Temporarily unavailable

34 No circuit available 503 Service unavailable

38 Network out of order 503 Service unavailable

41 Temporary failure 503 Service unavailable

42 Switching equipment congestion 503 Service unavailable

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 167 168

Kommentare zu diesen Handbüchern

Keine Kommentare

Dialogic 4000 SERIES Bedienungsanleitung Seite 81

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller Dialogic 4000 SERIES