Dialogic 4000 Series SU4.1 Bedienungsanleitung PDF herunterladen (Seite 46)

Dialogic 4000 Media Gateway Series SU4.1 Reference Guide

TCP listen port

If you use TCP as the IP protocol for calls from SIP, enable the check

box to display the standard port number 5060. This standard port can

be used if no other SIP application is running on the same computer

as Diva SIPcontrol. Note that you can only enable one network

interface.

TLS listen port

If you use TLS for encrypted calls, enable the check box to display

the standard port number 5061. You can change the port number,

but it must not be the same as the TCP Listen Port number. Note

that you can only enable one network interface. If you use TLS, you

need to upload security certificates and set the cipher level, as

described in Security Profiles.

RTP start port

Defines the lowest port of the range in which Diva SIPcontrol sends

and receives RTP streams. Change this value only if problems occur.

RTP end port

Defines the highest port of the range in which Diva SIPcontrol sends

and receives RTP streams. Change this value only if problems occur.

SIP Peers

A SIP peer is a specific endpoint to and from which Diva SIPcontrol will establish calls. The

peer-specific settings can be used to adapt Diva SIPcontrol's behavior towards this peer.

To add a SIP peer, click the Add button. To change the settings for the enabled SIP peer,

click the Details button on the right hand side. To open the online help for a specific

parameter, click the parameter, and a window with the help text will appear. The following

menus are available for configuration:

 General

 Enhanced

 Security

 Session Timer

 Address Normalization

 Authentication

General

You can configure the following parameters in the General section when you define or

modify a SIP Peer:

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 225 226

Keine Kommentare

Dialogic 4000 Series SU4.1 Bedienungsanleitung Seite 46