
ENGLISH
Dialogic® Diva® Media Board Installation Guide
page 59
Before any connection to PSTN offering Primary Rate Access to other national
or international E1 standards, please consult your Dialogic representative.
Dialogic
®
Diva
®
Analog Media Boards
This equipment has been tested against TBR 21 requirements (January 1998
edition - Terminal Equipment (TE) capable of 2-wire access to an analogue
Public Switched Telephone Network (PSTN), that is capable of originating a
circuit-switched call using Dual Tone Multi Frequency (DTMF) signaling and/or
receiving an incoming circuit-switched call).
Due to differences among the individual PSTNs provided in different countries,
compliance to TBR 21 does not, of itself, give an unconditional assurance of
successful operation on every PSTN network termination point.
In the event of problems, you should first contact your equipment supplier.
Conditions for TBR3, TBR4, and TBR 21 Compliance
To comply with the TBRs, be sure to adhere to the following requirements:
• The appropriate parameter file must be installed on the system and enabled
on these products. To enable it under Windows
®
, see below. For Linux, see
page 60.
Under Windows
®
:
1. Click Start > Programs > Dialogic Diva > Configuration Manager.
2. Click the icon of the Dialogic
®
Diva
®
Media Board in the Lines layer
of the Configuration Pane.
3. In the Properties Pane, select your country-specific protocol from
the dropdown menu under Country Selection (for Diva Analog Media
Boards) or under Switch Type (for Diva BRI and PRI Media Boards).
Note: The graphic on the next page shows the parameters and values
for a Diva Analog Media Board configuration. The available D-channel
protocols depend on the installed Diva Media Board. The menu options
for Diva BRI and PRI Media Boards are slightly different as well.
Kommentare zu diesen Handbüchern