
ENGLISH
International Regulatory Information
page 66
Regulatory information for Australia
Dialogic is required to provide the following information as a condition of the
telecommunications conformity of Dialogic
®
telecommunications products.
You may also be responsible for meeting requirements other than those
outlined in this document.
Note: Failure to meet the requirements listed may render the products
non-compliant, with the user liable to significant penalties under the
Telecommunications Act.
• This customer equipment shall only be installed in a PC that requires the
use of a tool to gain access to internal parts (e.g., this customer equipment
must not be installed in a PC with a "flip lid").
• Proper installation of the Dialogic
®
Diva
®
Media Board requires that it is
screwed to the metal backplate of the computer. This ensures proper
grounding, which is necessary for safety purposes.
• This customer equipment may only be installed in host equipment where
there is at least 2 mm of air gap between the customer equipment and
adjacent boards (PCBs).
• Only compliant line cord set(s) shall be used as replacements with this
customer equipment.
These products shall be used in a manner that complies with the technical
standards ACA TS 001 and ACA TS 002:
• The application software shall answer an incoming call by seizing the line
at least 2 seconds after the start of an application of ring signal from a
PSTN. A maximum time of 15 seconds is recommended.
WARNING: This customer equipment is to be installed and maintained by
service personnel as defined by AS/NZS 60950.1:2003
Service Personnel. It may be hazardous if your computer is
not properly plugged in and grounded.
CAUTION: This equipment must be installed and serviced by qualified
personnel. No user accessible parts inside.
IMPORTANT: This equipment will be inoperable when mains power fails.
Kommentare zu diesen Handbüchern