Dialogic DSI SS7MD Bedienungsanleitung PDF herunterladen (Seite 108)

108

Chapter 6 Command Definitions

6.12 Signaling Gateway Commands

The Signaling Gateway commands include:

• SGDPI - Signaling Gateway Destination Point Initiate

• SGDPC - Signaling Gateway Destination Point Change

• SGDPE - Signaling Gateway Destination Point End

• SGDPP - Signaling Gateway Destination Point Print

• SGIRI - Signaling Gateway Incoming Route Initiate

• SGIRC - Signaling Gateway Incoming Route Change

• SGIRE - Signaling Gateway Incoming Route End

• SGIRP - Signaling Gateway Incoming Route Print

• SGRKI - Signaling Gateway Routing Key Initiate

• SGRKE - Signaling Gateway Routing Key End

• SGRKP - Signaling Gateway Routing Key Print

6.12.1 SGDPI – Signaling Gateway Destination Point Initiate

Synopsis

This command initiates routing to a destination point identified by a routing key or incoming route.

Destination selection either selects an Remote Application Server (RAS) or attempts to route to the MTP or IP

side on a priority basis. If an Application Server is not configured, the Signaling Gateway attempts to find a

route to the Destination Point Code (DPC) of the received message over MTP or IP. The user can configure

whether to route the message via MTP or IP if the Point Code is available over both by setting the RTPRI

parameter.

A destination can either be a route (MTP or IP or a combination of both) or a Application Server. If both MTP

and IP routes are specified, the default priority indicates which route to the Point Code should be selected

first if available. MTPONLY and IPONLY state that no attempt to other domain should be made if the routes

through these domains are unavailable.

Syntax

SGDPI:DEST=,RTPRI=,[LABEL=,];

SGDPI:DEST=,RAS=,[LABEL=,];

Prerequisites

• The destination point has not already been initiated.

• An RAS, if specified, must serve only 1 destination.

• If an RAS is specified, it must be initialized.

• RTPRI cannot be set to NONE if an RAS is not present.

• NONE is the only value allowed for RTPRI if an RAS is present.

Attributes

CONFIG

Examples

SGDPI:DEST=1, RAS=1;

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 175 176

Keine Kommentare

Dialogic DSI SS7MD Bedienungsanleitung Seite 108