Dialogic DSI SS7MD Bedienungsanleitung PDF herunterladen (Seite 75)

Dialogic

DSI Signaling Server SGW Mode User Manual Issue 5

6.5.36 CNUSC – Change SNMP v3 User Configuration

Synopsis

This command allows the configuration of a previously registered SNMP v3 user to be changed. The USER

parameter identifies the user account to modify.

The parameters and associated values are as per the CNUSI command, with the additional parameters PRIV

and PRIVPASS. Supported PRIV parameter values are DES and AES. As with the AUTHPASS parameter value,

the privacy password value (PRIVPASS) must be between 8 and 24 characters long. Also, it is not possible to

configure or modify the PRIVPASS value for a user without also specifying the PRIV value. It is, however,

possible to modify the PRIV or AUTH values without additionally specifying a corresponding password.

Syntax

CNUSC:USER=[,AUTH=|,AUTHPASS=|,PRIV=|,PRIVPASS=|,LABEL=};

Prerequisites

The DSMI-based SNMP agent must be enabled.

The SNMP v3 user must already have an entry in the list of configured SNMP v3 users.

Attributes

CONFIG

Examples

CNUSC:USER=3,AUTH=SHA;

6.5.37 CNUSE – End SNMP v3

Synopsis

This command removes an SNMP v3 user's configuration entry. The command takes a single parameter,

USER, which identifies the user to be removed.

Syntax

CNUSE:USER=;

Prerequisites

The DSMI-based SNMP agent must be enabled.

The user must be present in the list of configured SNMP v3 users.

Attributes

CONFIG

Examples

CNUSE:USER=3;

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 175 176

Keine Kommentare

Dialogic DSI SS7MD Bedienungsanleitung Seite 75