Dialogic DSI SS7MD Bedienungsanleitung PDF herunterladen (Seite 80)

Chapter 6 Command Definitions

6.6.2 C7LSC – CCS SS7 Link Set Change

Synopsis

This command allows changes to the configuration of an SS7 link set.

Syntax

C7LSC:LS=,{[OPC=,][DPC=,][LSSIZE=,][NC=,][NI=,]};

Prerequisites

• The SS7 link set has already been initiated.

• All configured SS7 links must be blocked.

Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling

are blocked and then unblocked.

• The LSSIZE cannot be set to less than the number of links attached to the link set.

• DPC must be different across link sets.

• If SS7MD indicates a 14-bit Point Code, OPC and DPC must be less than or equal to 16383.

• Only one OPC can exist within a network context.

• The NC/DPC combination must be different for all link sets.

• The NC/OPC combination must be different for all link sets.

Attributes

CONFIG

Examples

C7LSC:LS=1,OPC=1,DPC=2,LSSIZE=2;

6.6.3 C7LSE – CCS SS7 Link Set End

Synopsis

This command is used to end the SS7 link set.

Syntax

C7LSE:LS=;

Prerequisites

• There should be no signaling links attached to the link set.

• All configured SS7 links within the system must be blocked.

Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling

are blocked and then unblocked.

• There are no C7 Routes using this link set.

Attributes

CONFIG

Examples

C7LSE:LS=1;

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 175 176

Keine Kommentare

Dialogic DSI SS7MD Bedienungsanleitung Seite 80