Dialogic DSI SS7MD Bedienungsanleitung PDF herunterladen (Seite 61)

Dialogic

DSI Signaling Server SGW Mode User Manual Issue 5

Syntax

Prerequisites

The DSMI-based SNMP agent must be enabled.

Attributes

CONFIG

Examples

CNOBS:OBJGRP=7,OBJECT=2,DOWN=all;

This will cause a TRAP to be generated whenever an SS7 link is created in the Down state, or destroyed while

in the Down state or when the link enters the Down state.

6.5.10 CNPCI – Configuration PCM Initiate

Synopsis

This command configures a PCM (PCM) for T1 or E1 operation (PCMTYPE) on a board such that it is available

for signaling or voice. The command optionally configures the PCM to be used as a potential synchronization

source for the system (SYNCPRI). The command also allows the frame format (FF) and line code (LC) to be

configured. See Section 7.1.2, “Boards and PCMs” on page 136 for a more detailed description of PCM

configuration.

Syntax

CNPCI:PCM=,PCMTYPE=,[SYNCPRI=,][FF=,][LC=,][IDLE=][BM=][BUILDOUT=,] [UNS=,];

Prerequisites

• The board on which the PCM exists has been initiated.

• The PCM has not already been initiated.

• For a PCMTYPE of E1, the LC can be set to HDB3 and the FF can be set to G704, CRC4, CRC4C or

CRC4G706.

• For a PCMTYPE of T1, the LC can be set to AMI or B8ZS and the FF can be set to SF, ESF or CRC6.

• An FF of CRC4G706 can only be set on a board type of SS7HDP.

• The BUILDOUT parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type

other than SS7HDP.

• A frame format of UNS can only be specified for PCMs on SS7HDP signaling boards.

Attributes

CONFIG

Examples

CNPCI:PCM=1-1,PCMTYPE=E1,SYNCPRI=1;

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 175 176

Keine Kommentare

Dialogic DSI SS7MD Bedienungsanleitung Seite 61