Dialogic DSI SS7MD Bedienungsanleitung PDF herunterladen (Seite 26)

Chapter 3 Licensing, Installation and Initial Configuration

3.2.6 Changing System Operation Mode

By default, the Signaling Gateway is shipped configured to operate in TEST mode. Once an SGW license has

been applied, the system must be restarted using the MNRSI MML command requesting that the unit operate

in SGW mode. Connect a VT100 terminal to identify the mode of operation (See Section 3.2.1, “Connecting a

VT100 Terminal” on page 22).

The MNRSI restart command should be used to restart the system in a different mode. MNRSI should be

used together with the mode in which the Signaling Gateway is expected to operate in after restart. For SGW

operation this is:

MNRSI:RESTART=SOFT,SYSTYPE=SGW;

3.2.7 Configuration Procedure

Once the system architecture and protocol configuration is known, it is necessary to set this configuration

within the Signaling Gateway. Configuration is achieved using MML commands as described in Chapter 6,

“Command Definitions”. An overview of configuration is provided in Chapter 7, “Configuration Overview” and

example configurations are described in Chapter 11, “Worked Configuration Examples”.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 175 176

Keine Kommentare

Dialogic DSI SS7MD Bedienungsanleitung Seite 26